US model of 1917 extraction problems: honing the chamber

My Model 1917 and I are still having trouble getting along, as I mentioned in several other posts. At Perry I ended up with some saved rounds in rapid prone due to ejection problems which did not make me happy.

While cleaning it i discovered that the chamber looks a little rough, probably a bit of rust. After unsuccessfully trying to clean it up with a chamber bush I ordered a 800 grain 30-06 “flex-hone” and the corresponding oil from midway.

I stripped the stock off and clamped the barrel between two wooden blocks in my big vice oiled the flex-hone lightly per instructions and ran it in and out for a very short time… Less than a minute.

20120829-211312.jpg

I won’t know how effective it was for a few weeks, the chamber is nice and shiny now and it still passes headspace so I have managed to break anything.

If you decide to try this be careful not to over polish and take the stock off so you don’t break it in the vice. I’m sure there are better ways to clamp it down, but I just used a couple boards and my big vice tightening it just enough to hold it firm at a “straight” part of the barrel.

UPDATE: this worked!!! While my initial “less than a minute” wasn’t enough I honed it again for longer maybe 3 minutes in and out. After I was done the shoulders were “white” so there was probably a lot of build up from years of shooting blanks.

HXP ejected like butter some of my reloads still needed some extra force but that could be related to me poorly sizing the brass. I may touch it up just a bit more but I am excited that I finally found a solution!

August Garand match

First “Home” match since perry. I lost a few more misses then I would like to admit on off-hand. Breaking at the wrong time, getting lazy with my stance all contributed.

I will spend some time dry firing between now and the next match. I still don’t feel great about my cheek wield and would like to make some adjustments to my sling.

Camp Perry CMP Games & National Matches: How It Works

When I first signed up for the cmp games matches I had no idea how it worked. I asked lots of questions and did lots of reading. I’ve tried to make this post a “step by step” report of my experience hopefully others will find it helpful.

After the long 9 hour drive down the mind numbing straight line that is the PA then OH turnpike I finally arrived at Camp Perry. There wasn’t much going on weds afternoon when I pulled up to the marksmenship center, no waiting, ample parking.

20120806-204920.jpg

Just stroll in and you’ll be given a paper to fill out your basic info for the base folks (license plate number, emergency contact) then you wait in line to be in processed where you will be given your score cards and some other basic info.

I didn’t realize this at the time so I went the next morning but if you get there the day before stop by the CMP trailer and get your trigger weighed. I never saw a line there but have been told it can take around an hour. It wasn’t clear to me if you “had to” or “should” get your trigger weighed as they didn’t seem to strict about it however if you make the cut off for a medal you wouldn’t want to be out of contention because of trigger weight.

20120806-210903.jpg

Day of the match

I signed up for the PM matches squadding starts at 10 the AM matches Squad at 6.

For the vintage match on Friday they let folks squad right away. I walked up around 9 and was assigned right away.

20120806-211704.jpg

For the Garand Match on Saturday they made us wait until 10 to squad so there was a long line.

20120806-211907.jpg

Note R. Lee Ermey (in shorts) waits in line with everyone else.

So how does Squadding work? Good question, I had no idea but someone was nice enough to explain it to me. You’ll be given a matrix but it made 0 sense to me.

20120807-195714.jpg

Here’s how it works. There are 4 relays you will be assigned to a relay and a firing position. In the example above, relay 1 shoots first while 2 scores. 3&4 are in the pits pulling targets together. Then 1&2 trade spots, after 2 is done 3&4 move to the line and 1&2 take their turn in the pit.

20120807-203822.jpg

To stand on a soapbox for a bit if you don’t want to work the pits, or think you will be too tired out, either don’t shoot or arrange ahead of time to pay someone to take your place.

Working the pits works just like any other pit. With one notable exception is the lack an impact area to watch. In this case the impact area is Lake Erie. The targets are “closer” than they were at the York Riflemen match I attended earlier in the year and it wasn’t pouring so it wasn’t difficult to see the hole. My partner taught me to stand at an angle and listen for the “crack” of the bullet as I goes over your head. It will take a few shoots but you will quickly be able to tell if it was your shooter.

20120807-201940.jpg

We had 3 stoppages while I was there for boats in the impact area. One time it stopped a rapid fire stage. Which was re-fired after we went hot. Many, including myself, learned the lesson to bring extra ammo.

There was a story going around the pits that someone on the AM relay Garand match on Viale stood on their stool when their shooter was done and looked over the pit wall towards the firing line. I’m not sure if this really happened and if it did what exactly he was trying to see but either way that’s a good way to get shot in the head by mistake. Don’t do that.

Some other odds an ends:

The shooters shuttle will take you around the camp. It’s a long walk to the assembly line on Viale even from a good parking spot.

20120807-204341.jpg

Some pictures of the line

20120807-204627.jpg

20120807-204702.jpg

The porta-John line gets long during the pit change.

20120807-204748.jpg

20120807-204945.jpg

Check out the pier while you are there.

20120807-205055.jpg

And stop in the north store and pick out a nice Garand or 6 while you are there.

20120807-205507.jpg

The infamous Camp Perry huts

20120807-205610.jpg

Stop by commercial row and max out a credit card or two.

20120807-205719.jpg

20120807-205832.jpg

First Trip to Camp Perry

I’m back from my first trip to Perry and I’m very glad I made the trip. As I mentioned in my first post I signed up for the afternoon matches for vintage military on friday and John C. Garand on Saturday.

I had trouble with my 1917 which cost me posting a reasonable score. However I made it up on Saturday breaking my personal record by 7 points. I met some great folks and picked up some helpful tips. I’m excited For next year. I am going to try and chase a bronze medal next year.

I’ll do a full AAR in my next post.

20120806-201958.jpg

July John C. Garand Match

I had a great match this weekend with my Garand. My best match yet with a final score of 230 1X!

20120723-201207.jpg

My new Creedmoor jacket seemed to help, especially in prone. Off hand seemed much more stable however I struggled with my ear pro as my cheek weld was a bit off with the extra material in my shoulder. This cost me a couple (ok three) misses. However I seem to have gotten the hang of it and I’ll use my low profile ear pro at Camp Perry. Which is quickly approaching!